Osha Roof Safety Monitoring System

A steep roof has a slope greater than 4 in.

Osha roof safety monitoring system.

This instruction clarifies the use of a safety monitoring system to comply with 29 cfr 1926 500 g 1. Osha instruction std 3 11 1. Most workers can be protected with conventional fall protection systems such as guardrails safety nets and personal fall arrest systems. According to osha a monitoring system can be used in combination with the solutions provided above.

1926 502 h 2 mechanical equipment shall not be used or stored in areas where safety monitoring systems are being used to monitor employees engaged in roofing operations on low slope roofs. This requires the designation of a competent person to monitor the safety of workers and to warn them when their work puts them close to a fall hazard. If you are a roofing contractor in the united states with at least one employee you are required to abide by osha safety standards. Protect employees who are working at heights.

As far as osha is concerned there is no safe distance from the edge of a roof so you must be protected. The warning line system shall consist of ropes wires or chains and supporting stanchions 29 cfr 1926 502 f 2. That person needs to be on the same walking working surface and warns the worker s when fall hazards are observed. Low slope roof safety monitoring systems 29 cfr 1926 501 b 10 permits employers to protect employees engaged in roofing activities on low sloped roofs from falling by several means one of which is the use of a safety monitoring system in combination with a warning line system.

The safety monitor is always a competent person 29 cfr 1926 500 b. 29 cfr 1926 501 b 10 allows the use of a safety monitor on a low slope roof. Oregon osha s division 3 construction rules set the requirements for the types of fall protection systems that can be used to. Vertical per 12 in.

A safety monitoring system is an alternative fall protection option for low slope roofing work. Safety monitoring system as it applies to 29 cfr 1926 500 g 1 a. Division 3 subdivision m. When engaged in roofing work on low slope roofs 50 ft or less in width the use of a safety monitoring system without a warning line system is permitted.

Aerial lifts may be used to transport personnel so long as the requirements in 29 cfr 1926 453 which cover aerial lifts are met. Osha occupational safety and health administration is a us government agency regulating workplace safety. This means a competent person monitors the worker s on a low slope roof. This means that you must have rails fall arrest systems or a warning line safety monitor setup no matter where it is you are working.

However 1926 501 b 10 further provides that. If you work alone you are not required to abide by osha standards. Section 1926 453 b 2 v requires that employees working from aerial lifts be tied off. This instruction applies osha wide.

Safety monitoring for roofing work. Or on roofs 50 feet 15 25 m or less in width the use of a safety monitoring system alone is permitted 29 cfr 1926 501 b 10.