Osha Hard Hat Requirements Roofing

Hard hat or no hard hat safety must take priority on a roofing jobsite.

Osha hard hat requirements roofing.

Class e electrical hard hats are rated for 20 000 volts. An osha hard hat expiration date does not exist but manufacturers may set a specific date for expiration. Class c conductive hard hats do not offer electrical protection. 1926 100 hard hat testing and certification requirements when the hard hat bill is worn to the rear.

According to the ansi isea standard hard hats must also contain user information such as instructions pertaining to sizing care and service life guidelines. 04 17 2002 1926 100 hard hats are not required where there is no exposure to head injuries. What are the different ansi hard hat categories. Osha s general industry and construction head protection standards 1910 135 and 1926 100 respectively do not require workers to wear hard hats when there is no risk of head injury.

However even where there may not be an osha requirement to wear head protection numerous employers require 100 percent hard hat use as a company policy. Every hard hat conforming to the requirements of ansi z89 1 2014 must be appropriately marked to verify its compliance. Class g general hard hats are rated for 2 200 volts. Osha hard hat replacement requirements must be considered when hats bear cracks dents penetration or even wear from rough care and treatment.

In your scenario where no work is being performed overhead and there is no employee exposure to possible head injuries there is no osha requirement that hard hats be worn while on the roof. This is in response to your fax dated september 6 2004 to the directorate of construction of the occupational safety and health administration osha. This may seem extreme but failure to provide your roofers with the required personal protective equipment ppe could result in a preventable injury on the jobsite and an investigation from osha. A universal hard hat policy is common on construction sites where workers work on roofs as well as other areas of the jobsite.

Code 29 cfr 1910 135 refers to head protection requirements for general industry workers and 29 cfr 1926 100 governs hard hat requirements for workers in construction demolition and renovation. Most replace their hard hats every 5 years. They do not prohibit employers from adopting more stringent requirements. The following information must be marked inside the hard hat.

Osha will deem any head protection device that the employer demonstrates is at least as effective as a head protection device constructed in accordance with one of the consensus standards identified in paragraph b 1 of this section to be in compliance with the requirements of this section. Note that osha standards set minimum safety and health requirements.